Talk:Sensitivity (electronics)

Professional sound production Low‑importance

	This article is within the scope of WikiProject Professional sound production, a collaborative effort to improve the coverage of sound recording and reproduction on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.Professional sound productionWikipedia:WikiProject Professional sound productionTemplate:WikiProject Professional sound productionProfessional sound production articles
Low	This article has been rated as Low-importance on the project's importance scale.

Electronics Mid‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

What is the millivolt measurement? RMS? Peak-to-peak? — Omegatron 20:59, 14 March 2007 (UTC)[reply]

Merger proposal

Sensitivity (radio receiver) seems to cover a very related topic of low-level signals detection. Should it be merged here? Calimo (talk) 15:49, 14 January 2009 (UTC)[reply]

I fully agree. In electronics the main usage of sensitivity is for a radio. It would be useful to discuss which is the relationship between sensitivity and attenuation (i.e. given a source and an homogeneous medium which is the distance up to which a radio receiver with a given sensitivity can be used). MM —Preceding unsigned comment added by 195.176.178.209 (talk • contribs) 15:24, 23 February 2009

trdj —Preceding unsigned comment added by 203.153.35.66 (talk) 12:00, 7 May 2009 (UTC)[reply]

I would like to note that -- despite claims on this and the responsivity page -- transducer responsivity is still widely (read: almost exclusively) called "transducer sensitivity." In fact, all this page does is mention receiver sensitivity, claim that responsivity is mistakenly called sensitivity, then give a general introduction to transducer responsivity anyway. It would be best to Just have this page stub for both Sensitivity (radio receiver) and Responsivity, while doing a better job of clarifying which is which. —Preceding unsigned comment added by 64.194.95.78 (talk) 21:34, 26 May 2009 (UTC)[reply]

Sensitivity/Responsivity

I share the opinion of Kaajakari[1] and Korvink[2] that sensitivity is the change in output divided by change in input and is the same as responsivity. Further they write that resolution is the minimum signal which can be detected, which is defined here as sensitivity. I think nearly every good scientific book think the same way and I have never read something different.

[1] V. Kaajakari, Practical MEMS

[2] J. G. Korvink and O. Paul, MEMS: A Practical Guide to Design, Analysis, and Applications — Preceding unsigned comment added by 212.114.212.115 (talk) 08:59, 1 July 2016 (UTC)[reply]