Jump to content

Titan II GLV

From Wikipedia, the free encyclopedia
(Redirected from Gemini-Titan II (rocket))

Titan II GLV
Launch of Gemini 11 on a Titan II GLV from LC-19
FunctionHuman-rated launch vehicle for Gemini spacecraft
ManufacturerMartin
Country of originUnited States
Size
Height109 ft (33 m)[1]
Diameter10 ft (3.0 m)
Mass340,000 lb (150 t)
Stages2
Capacity
Payload to LEO[altitude and inclination needed]
Mass7,900 lb (3.6 t)
Associated rockets
FamilyTitan
Launch history
StatusRetired
Launch sitesCape Canaveral LC-19
Total launches12
Success(es)12
First flightApril 8, 1964
Last flightNovember 11, 1966
Type of passengers/cargoGemini
First stage
Powered by1 LR87-AJ-7
Maximum thrust430,000 lbf (1,900 kN)
Specific impulse258 s
Burn time156 seconds
PropellantAerozine 50 / N2O4
Second stage
Powered by1 LR91-AJ-7
Maximum thrust100,000 lbf (440 kN)
Specific impulse316 s
Burn time180 seconds
PropellantAerozine 50 / N2O4

The Titan II GLV (Gemini Launch Vehicle) or Gemini-Titan II was an American expendable launch system derived from the Titan II missile, which was used to launch twelve Gemini missions for NASA between 1964 and 1966. Two uncrewed launches followed by ten crewed ones were conducted from Launch Complex 19 at the Cape Canaveral Air Force Station, starting with Gemini 1 on April 8, 1964.

The Titan II was a two-stage liquid-fuel rocket, using a hypergolic propellant combination of Aerozine 50 fuel and nitrogen tetroxide oxidizer. The first stage was powered by an LR87 engine (with two combustion chambers and nozzles, fed by separate sets of turbomachinery),[2][3] and the second stage was propelled by an LR-91 engine.

Modifications from the Titan II missile

[edit]
Titan II GLV first stage component assembly scheme.
Titan II GLV second stage component assembly scheme.
Titan with Gemini capsule in the Transonic Dynamics Tunnel (1964).

In addition to greater payload capability, the Titan II promised greater reliability than the Atlas LV-3B, which had been selected for Project Mercury, because Titan's hypergolic-fueled engines contained far fewer components.[citation needed]

Several modifications were made to the Titan missile to human-rate it for Project Gemini:[4]

  • A "Gemini Malfunction Detection System" was installed to inform the crew of the rocket's status, and improve response in an emergency.
  • Redundant systems were installed to reduce the chances of launch failures.
  • The inertial guidance system was replaced by a lighter-weight ground-radio guidance system
  • The avionics truss in the second stage was modified slightly
  • To help guard against the possibility of a guidance malfunction causing the engine nozzles to gimbal hard right or left, an extra backup guidance system was added.
  • The second stage propellant tanks were lengthened for longer burn time and unnecessary vernier engines and retrorockets were removed. Because the second stage engine had had issues with combustion instability, it was equipped with baffled injectors.
  • The first stage was loaded with 13,000 pounds (5.9 t) more propellant than the Titan ICBM although the storage tank size remained unchanged.
  • Modifications were made to the tracking, electrical and hydraulics systems in the interest of improved reliability.
  • The propellants were chilled to slightly improve vehicle performance. This allowed for more mass to be accommodated.
  • First stage engine thrust was reduced slightly to cut down on vibration and G loads.
  • First stage engine burn would go until propellant depletion unlike Titan ICBMs which were designed to cut off when propellant flow/pressure and engine thrust started dropping as the tanks emptied. This was to prevent the possibility of a malfunctioning pressure sensor triggering an abort condition. Also, running until depletion would slightly boost the Titan's capacity for payload.

Modifications were overseen by the Air Force Systems Command. The Aerojet company, the manufacturer of the Titan's engines, had released a revised model during mid-1963 due to deficiencies in the original design, and also to attempt to improve manufacturing procedures.[citation needed]

Film footage of Gemini 10's launch revealed that the first stage oxidizer tank ruptured shortly after staging and released a cloud of N2O4. As first stage telemetry had been terminated at staging, there was no data other than photographic/visual evidence to go by, however the conclusion was that either loose debris struck the oxidizer tank dome or else exhaust from the second stage engine had burned through it.[citation needed]

Gemini 12's launch vehicle also experienced a tank rupture after staging and film review of Titan II ICBM launches found several occurrences of this phenomenon. Since this did not appear to pose any safety risks to the astronauts, NASA decided that it was not a concern.[citation needed]

During Titan II ICBM development, it had been found that the first stage turbopump gearbox was prone to total failure caused by resonant vibration in the idler gear. This problem had not occurred on actual launches, but only static firing tests. This was considered to be a critical item to fix. Aerojet developed a totally redesigned gearbox, and all of Gemini launch vehicles except for the uncrewed Gemini 1 used it.[citation needed]

There was also a potentially serious problem with the turbopump bearings which led to more design changes, however the odds of failing on a Gemini launch were slim to nil since GLV boosters used specially selected and tested bearings, in addition the turbopumps would be "hot fired" as part of prelaunch checks[citation needed]

Combustion instability in the second stage engine was also a concern although that too had only been witnessed in static firing runs. A new injector with improved baffling was developed for the engine and flight-tested on a Titan IIIC launch; all GLVs from Gemini 8 onwards incorporated it.[citation needed]

After a Titan II propellant feed line was found to have some damage during factory inspections, NASA put out the requirement that all GLV propellant lines had to be X-rayed in order to prevent a potentially disastrous fuel leak during launch. X-ray tests later found several more damaged propellant lines, most likely due to careless handling.[citation needed]

The most significant issue in man-rating the Titan II was resolving problems with resonant vibration known as "pogo" (since the action was said to resemble that of a pogo stick) that could produce g-forces sufficient to incapacitate astronauts,[citation needed] but the Air Force were not interested in helping NASA with a problem that did not affect the ICBM program and could potentially delay it, or require major modifications to the design. However, Martin-Marietta argued that the pogo problem could be fixed fairly easily, and also the Air Force began to develop more of an interest in man-rating the Titan II due to the proposed Manned Orbiting Laboratory program. The primary changes made to resolve pogo were adding oxidizer standpipes, increasing the pressure in the propellant tanks, and adding a mechanical accumulator to the fuel suction side.[5]

Another nuisance problem that occurred during the Gemini program was code-named "Green Man" and involved momentary pitch oscillations of the Titan second stage following engine cutoff. This phenomenon had happened on both Gemini and uncrewed Titan II/III flights and had resulted in the failure of the ablative skirt on the second stage at least twice (those instances were dubbed "Brown Man"). Investigation following skirt failure on a Titan IIIC launch concluded that pressure buildup in the ablative skirt caused the pitch oscillations, but NASA decided that there was probably little chance of loose debris from the skirt contacting the Gemini spacecraft, so no corrective action had to be taken and in any case, the Titan IIIC incident was found to be the result of poor quality control which would not affect the more strictly supervised Gemini program.[citation needed]

The assembly of these rockets was done at Martin-Marietta's plant in Baltimore, Maryland, so not to interfere with missile work at the one in Denver, Colorado, although this also saved the former plant from a planned shutdown. As with the Mercury-Atlas launch vehicles, a high degree of workmanship was stressed as well as more thorough testing of components and improved handling procedures compared with Titans designed for uncrewed flights.[6]

Flights

[edit]
Titan II GLV launches

The Titan II had a much higher thrust-to-weight ratio than the Saturn V. Astronauts experienced almost 6G before the second stage stopped firing at 100 miles (160 km) altitude. Richard F. Gordon Jr. compared the Titan II to "a young fighter pilot's ride. It's faster than the Saturn's old man's ride." Frank Borman said that simulations did not prepare him for the "almost deafening" noise, which he compared to a jet's afterburner or large train. Walter Schirra and Gordon Cooper reported that the ride was smoother than on the Atlas, however.[7]

Mission LV serial No Launch date Crew
GT-1 GLV-1 12556 April 8, 1964 Uncrewed orbital test flight
GT-2 GLV-2 12557 January 19, 1965 Uncrewed suborbital test of Gemini heat shield
GT-3 GLV-3 12558 March 23, 1965 Gus Grissom and John Young
GT-IV GLV-4 12559 June 3, 1965 James McDivitt and Ed White
GT-V GLV-5 12560 August 21, 1965 Gordon Cooper and Charles P. Conrad
GT-VII GLV-7 12562 December 4, 1965 Frank Borman and Jim Lovell
GT-VI A GLV-6 12561 December 15, 1965 Wally Schirra and Thomas P. Stafford
GT-VIII GLV-8 12563 March 16, 1966 Neil Armstrong and David Scott
GT-IX A GLV-9 12564 June 3, 1966 Thomas P. Stafford and Eugene Cernan
GT-X GLV-10 12565 July 18, 1966 John Young and Michael Collins
GT-XI GLV-11 12566 September 12, 1966 Charles P. Conrad and Richard F. Gordon
GT-XII GLV-12 12567 November 11, 1966 Jim Lovell and Edwin "Buzz" Aldrin

Displays

[edit]

Two retired Titan II missiles are on display repainted as Gemini Launch Vehicles, along with a few replicas.

See also

[edit]

References

[edit]
  1. ^ Gatland, Kenneth (1976), Manned Spacecraft (2nd revision ed.), New York: MacMillan, p. 37, ISBN 0-02-542820-9
  2. ^ Sutton, George P. (2006). History of liquid propellant rocket engines. Reston, Va.: American Institute of Aeronautics and Astronautics. pp. 381, 384. ISBN 1-56347-649-5. OCLC 63680957.
  3. ^ "Aerojet-General LR87 Liquid Rocket". National Museum of the US Air Force. Archived from the original on December 25, 2010. Retrieved December 25, 2010.
  4. ^ Simplicity, Duplication Will Give Titan 2 Manned Flight Capability, Aviation Week & Space Technology, September 3, 1962 pages 38-45
  5. ^ Hacker and Grimwood, p. 105
  6. ^ "New Image - ONLY - Scan to PDF" (PDF). Retrieved October 13, 2018.
  7. ^ Agle, D. C. (September 1998). "Riding the Titan II". Air & Space.
  8. ^ Robert Z. Pearlman (September 24, 2010). "Gemini-Titan Rocket Rises Again at Kennedy Space Center". Space.com. Retrieved September 20, 2023.
  9. ^ "A Field Guide to American Spacecraft". March 27, 2019. Archived from the original on March 27, 2019. Retrieved September 20, 2023.
  10. ^ "A Field Guide to American Spacecraft". March 27, 2019. Archived from the original on March 27, 2019. Retrieved September 20, 2023.
  11. ^ "A Field Guide to American Spacecraft | KCSC Gemini-Titan". March 27, 2019. Archived from the original on March 27, 2019. Retrieved September 20, 2023.
  12. ^ "A Field Guide to American Spacecraft". March 18, 2019. Archived from the original on March 18, 2019. Retrieved September 20, 2023.
  13. ^ "A Field Guide to American Spacecraft". March 27, 2019. Archived from the original on March 27, 2019. Retrieved September 20, 2023.
  14. ^ "Rare rocket delivery: Gemini-Titan display arrives in Houston | collectSPACE". collectSPACE.com. Retrieved September 20, 2023.

References

[edit]
  • Krebs, Gunter. "Titan-2-GLV". Gunter's Space Page. Retrieved April 29, 2009.
  • Wade, Mark. "Titan". Encyclopedia Astronautica. Archived from the original on August 5, 2008. Retrieved April 29, 2009.
[edit]

Media related to Titan II Gemini at Wikimedia Commons