Talk:Rubber toughening

This article is within the scope of WikiProject Polymers, a project which is currently considered to be inactive.PolymersWikipedia:WikiProject PolymersTemplate:WikiProject PolymersPolymers articles

Technology

This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles

Wiki Education Foundation-supported course assignment

This article is or was the subject of a Wiki Education Foundation-supported course assignment. Further details are available on the course page. Student editor(s): PleaseSirMore.

Above undated message substituted from Template:Dashboard.wikiedu.org assignment by PrimeBOT (talk) 08:25, 17 January 2022 (UTC)[reply]

Impact on plastics recycling?

Does rubber toughening make plastics difficult or impossible to recycle? Most recycling processes require purifying the material to prevent process contamination. It seems possible that a toughening coating may not be separable and may foul the purification process, but I am not a polymer engineer or scientist. DMahalko (talk) 12:21, 24 February 2009 (UTC)[reply]

Interesting question. If there is strong adhesion between the surfaces it should make them difficult to recycle. On the bright side, lots of waste materials (rubber and polymers) can be reused once incorporated into a toughened nanocomposite. PleaseSirMore (talk) 20:49, 17 May 2017 (UTC)[reply]

Find more information here: http://link.springer.com/referenceworkentry/10.1007/978-94-007-6064-6_23 PleaseSirMore (talk) 20:51, 17 May 2017 (UTC)[reply]

Proper Citation

The third paragraph lacks a source and it may soon be removed. "Well-known rubber toughened polymers include high impact polystyrene (HIPS), rubber-toughened nylon, and acrylonitrile butadiene styrene (ABS). In HIPS, polybutadiene domains are dispersed in a polystyrene matrix; in rubber-toughened nylon, typically cis-polyisoprene is dispersed in a Nylon matrix; in ABS, polybutadiene domains are again used, but for both polystyrene and acrylonitrile. For all cases, the inclusion of the rubber domains make these rubber toughening versions much more suitable for high-toughness applications."PleaseSirMore (talk) 12:57, 5 May 2017 (UTC)[reply]

The last sentence in the lead lacks proper citation and the second part of the second paragraph lacks proper citation.PleaseSirMore (talk) 12:59, 5 May 2017 (UTC)[reply]

The last sentence of the lead is unclear. It seems to try to conclude toughening is only due to the addition of rubber particles. However, it in fact reads that toughening is due only to preventing crack propagation, which is quite a big conclusion that would need proper backing in literature.PleaseSirMore (talk) 13:05, 5 May 2017 (UTC)[reply]

I have started work on adding some appropriate and needed citations. GRALISTAIR (talk) 14:16, 18 May 2021 (UTC)[reply]