Talk:Cun (unit)

This article is within the scope of WikiProject Measurement, a project which is currently considered to be defunct.MeasurementWikipedia:WikiProject MeasurementTemplate:WikiProject MeasurementMeasurement articles

China Low‑importance

	China portal This article is within the scope of WikiProject China, a collaborative effort to improve the coverage of China related articles on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.ChinaWikipedia:WikiProject ChinaTemplate:WikiProject ChinaChina-related articles
Low	This article has been rated as Low-importance on the project's importance scale.

East Asia (defunct)

This article is within the scope of WikiProject East Asia, a project which is currently considered to be defunct.East AsiaWikipedia:WikiProject East AsiaTemplate:WikiProject East AsiaEast Asia articles

Cun is a relative unit in acupuncture point location

Reading this article gives the impression of a fixed length definition for 1 cun. This is not correct for the use of the cun in location of acupuncture points. It is always used relative to the body part measured. The external link 'cun measurements' at the end of the article shows the 'definitions' used on different areas on the body. This should be clarified. --Nicolasnicolas (talk) 11:29, 10 December 2009 (UTC)[reply]

That's right, it is relative to the person. 1 cun (width of the thumb at the beginning of the nail) is different for each person. The measurement was created to find acupoints on people of all different sizes. Source: Five Dragons Acupuncture College Course. Perhaps we should make it part of wikiproject acupuncture. Family Guy Guy (talk) 04:13, 18 December 2018 (UTC)[reply]

Also units of angle: du, zhang, chi and cun

See Talk:Chi (unit)#Also units of angle: du, zhang, chi and cun --Matthiaspaul (talk) 15:54, 21 October 2015 (UTC)[reply]

Also I believe that pouce is a synonym for cun, but I can't find a canonical source.

Family Guy Guy (talk) 04:07, 18 December 2018 (UTC)[reply]