Talk:Angle of arrival

This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles

Radio Low‑importance

This article is within the scope of WikiProject Radio, a collaborative effort to improve the coverage of Radio-related subjects on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.RadioWikipedia:WikiProject RadioTemplate:WikiProject RadioRadio articles

Low

This article has been rated as Low-importance on the project's importance scale.

To-do List:

Here are some tasks awaiting attention:

Article requests : Create: Missing years and articles in radio, National Association of Radio Distress-Signalling and Infocommunications (Hungary)
Assess : Unassessed Radio articles; Unknown-importance Radio articles
Cleanup : Radio articles needing attention
Expand : Midweek Politics Bob Crane
Maintain : Portal:Radio
Stubs : Expand: Radio stubs
Verify : Unreferenced BLPs
Other : Collaboration of the Week:
Requests for Radio peer review:

So what is the exact difference between "Angle-of-Arrival" and "Direction-of-Arrival"? The DoA article points to the AoA article, but this does not really make it clear. Mbssch 17:29, 26 February 2007 (UTC)[reply]

Direction of Arrival defines the vector from you...or you platform to the target. Angle of Arrival is relative your sensor orientation....Generally its the 2-D plane that defines your sensor

This article is very imcomplete. AOA in general has nothing to do with TOA. Angle of arrival is the projection of the 3-D direction of Arrival onto the AOA plane. The most popular form of AOA is monopulse. A beamformer is used to generate a sum and difference beam. Comparing the ratios of measurements in the Sum beam and difference beam allows for the AOA estimate. A calbration table is used to lookup a voltage which will equate to the AOA required to get that voltage. Once looked... up you can project back to the DOA vector onto the the local tangent...(nominally ref in East North Up coord)....Those than can be covered to ECEF or GEODECTIC..... — Preceding unsigned comment added by 96.255.231.183 (talk) 00:49, 20 June 2013 (UTC)[reply]

Bluetooth 5.1

Should there be a paragraph or section on the addition of AoA/AoD to the Bluetooth 5.1 standard? ThePlug111 (talk) 23:20, 3 September 2022 (UTC)[reply]