User talk:Ahnode
Appearance
|
Posts
[edit]привет, я тебе писал на почту через Wikipedia, но письмо видимо не дошло. У меня есть деловое предложение, если есть возможность, добавь меня в FB, https://www.facebook.com/miosavior
Air_sensitive_cannula_-_syringe_valve_1.png
[edit]Ahnode
Your image is great, very nice indeed:
Some comments to make it even better.
- The device 12-14 is a normal gas syringe see [[1]] and should really have a square not round end.
- the joints on 6 and 7 should have tight fitting rubber see septum (see [[2]] to make an air tight seal (these can be see in this picture as cream-coloured rubber seals, see also [[3]] for more information.
- the part 11 is really a metal three way tap see [[4]] - the syringe plugs into the female joint facing you, and the side arms fit to two needles. The ends of the needle have suitable female receiving joints to fit to this 3 way tap (luer lock).
Hope that makes sense!
Thanks again
-- Quantockgoblin (talk) 14:45, 29 September 2008 (UTC)
?
[edit]Hi, just wondering why you removed my image request from the Graphics Lab? I haven't been contacted about anything yet. --SteelersFanUK06 ReplyOnMine! 11:55, 10 December 2008 (UTC)
- I removed it from the Discussion section of the Graphic Lab and put in the the request section itself. Now it's here. --Ahnode (talk) 14:57, 10 December 2008 (UTC)
- Ah ok. No-one told me that. Edit summary would have been nice. --SteelersFanUK06 ReplyOnMine! 15:05, 10 December 2008 (UTC)
- Sorry didn't think of that, i'll keep that in my mind. --Ahnode (talk) 15:37, 10 December 2008 (UTC)
- Ah ok. No-one told me that. Edit summary would have been nice. --SteelersFanUK06 ReplyOnMine! 15:05, 10 December 2008 (UTC)