Jump to content

Tetraborane

From Wikipedia, the free encyclopedia
(Redirected from Tetraborane(10))
Tetraborane
ball-and-stick model of tetraborane
Names
IUPAC names
tetraborane(10)
arachno-B4H10
Identifiers
ChEBI
ChemSpider
UNII
  • InChI=1S/B4H10/c5-1-3(5)2(7-3)4(1,3,6-1)8-2/h3-4H,1-2H2 checkY
    Key: WEYOKDYZYYMRSQ-UHFFFAOYSA-N checkY
  • InChI=1/B4H10/c5-1-3(5)2(7-3)4(1,3,6-1)8-2/h3-4H,1-2H2
    Key: WEYOKDYZYYMRSQ-UHFFFAOYAQ
Properties[1]
B4H10
Molar mass 53.32 g/mol
Appearance colourless gas
Density 2.3 kg m−3 (gas)
Melting point −120.8 °C (−185.4 °F; 152.3 K)
Boiling point 18 °C (64 °F; 291 K)
Hazards
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 4: Very short exposure could cause death or major residual injury. E.g. VX gasFlammability 4: Will rapidly or completely vaporize at normal atmospheric pressure and temperature, or is readily dispersed in air and will burn readily. Flash point below 23 °C (73 °F). E.g. propaneInstability 3: Capable of detonation or explosive decomposition but requires a strong initiating source, must be heated under confinement before initiation, reacts explosively with water, or will detonate if severely shocked. E.g. hydrogen peroxideSpecial hazard W: Reacts with water in an unusual or dangerous manner. E.g. sodium, sulfuric acid
4
4
3
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)

Tetraborane (systematically named arachno-tetraborane(10)) was the first boron hydride compound to be discovered.[2] It was classified by Alfred Stock and Carl Massenez in 1912 and was first isolated by Stock.[3] It has a relatively low boiling point at 18 °C and is a gas at room temperature. Tetraborane gas is foul smelling and toxic.

History

[edit]

The class of boranes was elucidated using X-ray diffraction analysis by Lipscomb et al. in the 1950s. The X-ray data indicated two-electron multicenter bonds. Later, analysis based on high-resolution X-ray data was performed to analyze the charge density.[4]

Structure

[edit]

Like other boron hydride clusters, the structure of tetraborane involves multicenter bonding, with hydrogen bridges or protonated double bonds. According to its formula, B4H10, it is classified as an arachno-cluster and has a butterfly geometry, which can be rationalized by Wade's rules.[5] Each boron is sp3 hybridized, and “the configuration of the three hydrogens surrounding borons B1 and B3 is approximately trigonal and suggests approximately tetrahedral hybridization for these borons which would predict bond angles of 120°.”[6]: 35  However, the boron arrangements can be classified as fragments of either the icosahedron or the octahedron because the bond angles are actually between 105° and 90°.[6]: 3 

The comparison of the diffraction data from X-ray diffraction and electron diffraction gave suspected bond lengths and angles: B1—B2 = 1.84 Å, B1—B3= 1.71 Å, B2—B1—B4= 98 ̊, B—H = 1.19 Å, B1—Hμ = 1.33 Å, B2—Hμ =1.43 Å.[6]: 3 

Preparation

[edit]

Tetraborane can be produced via a reaction between acid and magnesium or beryllium borides, with smaller quantities from aluminum, manganese, and cerium borides.[7] Hydrolysis of magnesium boride, hydrogenation of boron halides at high temperatures and the pyrolysis of diborane also produce tetraborane. The hydrolysis of magnesium boride was one of the first reactions to give a high yield (14%) of tetraborane.[citation needed] Phosphoric acid proved to be the most efficient acid (compared to hydrochloric and sulfuric acid) in the reaction with magnesium boride.[8]

Isomers

[edit]

Scientists are currently[when?] working to produce the bis(diboranyl) isomer of the arachno-tetraborane structure. The bis(diboranyl) is expected to have a lower energy at the Hartree-Fock method (HF) level. There is some evidence that the bis(diboranyl) isomer is initially produced when synthesizing tetraborane by the Wurtz reaction or coupling of B2H5I in the presence of sodium amalgam. Three pathways of conversion from the bis(diboranyl) isomer into the arachno-tetraborane structure have been constructed computationally.

Path 1: Dissociative pathway via B3H7 and BH3
Path 2: Concerted pathway over two transition states separated by a local minimum
Path 3: Another concerted pathway involving penta-coordinated isomers as intermediates

Paths 2 and 3 are more likely, because they are more energetically favored with energies of 33.1 kcal/mol and 22.7 kcal/mol respectively.[9]

Safety

[edit]

Because it is easily oxidized it must be kept under vacuum. Tetraborane ignites when it comes in contact with air, oxygen, and nitric acid. Boranes in general including tetraborane have been deemed very toxic and are biologically destructive. A study consisting of small daily exposure of the chemical to rabbits and rats resulted in fatality.[10]

References

[edit]
  1. ^ Weast, Robert C., ed. (1981). CRC Handbook of Chemistry and Physics (62nd ed.). Boca Raton, FL: CRC Press. p. B-84. ISBN 0-8493-0462-8.
  2. ^ Wiberg, E. (1977-01-01). "Alfred Stock and the renaissance of inorganic chemistry". Pure and Applied Chemistry. 49 (6): 691–700. doi:10.1351/pac197749060691. ISSN 1365-3075.
  3. ^ Stock, Alfred; Massenez, Carl (1912-10-01). "Borwasserstoffe". Berichte der Deutschen Chemischen Gesellschaft. 45 (3): 3539–3568. doi:10.1002/cber.191204503113. ISSN 0365-9496.
  4. ^ Förster, Diana; Hübschle, Christian B.; Luger, Peter; Hügle, Thomas; Lentz, Dieter (2008). "On the 2-Electron 3-Center B−H−B Bond: Charge Density Determination of Tetraborane(10)". Inorganic Chemistry. 47 (6): 1874–1876. doi:10.1021/ic701924r. ISSN 0020-1669. PMID 18271535.
  5. ^ Grimes, Russel N. "Boron." Advanced Inorganic Chemistry. By F. Albert Cotton, Geoffrey Wilkinson, Carlos A. Murillo, and Manfred Bochmann. 6th ed. N.p.: n.p., 1999. 143-46. Print.
  6. ^ a b c Lipscomb, William N. Boron Hydrides. New York: W. A. Benjamin, 1963. Print.
  7. ^ Stock, Alfred (1933). Hydrides of Boron and Silicon. Cornell University Press. p. 60.
  8. ^ Stock, Alfred (1933). Hydrides of Boron and Silicon. Cornell University Press. p. 41.
  9. ^ Ramakrishna, Vinutha; Duke, Brian J. (2004). "Can the Bis(diboranyl) Structure of B4H10 Be Observed? The Story Continues". Inorganic Chemistry. 43 (25): 8176–8184. doi:10.1021/ic049558o. ISSN 0020-1669. PMID 15578859.
  10. ^ "Archived copy" (PDF). Archived from the original (PDF) on 2011-07-27. Retrieved 2011-05-11.{{cite web}}: CS1 maint: archived copy as title (link)
[edit]