Talk:Time base correction

	Film portal This article is within the scope of WikiProject Film. If you would like to participate, please visit the project page, where you can join the discussion and see lists of open tasks and regional and topical task forces. To use this banner, please refer to the documentation. To improve this article, please refer to the guidelines.FilmWikipedia:WikiProject FilmTemplate:WikiProject Filmfilm articles
	This article is supported by the Filmmaking task force.
	This article needs an image (preferably free) related to the subject, such as a picture of the set or a film poster. Please ensure that non-free content guidelines are properly observed.

Timebase or Time base?

Title uses timebase. Lead uses time base. Body uses both. --Kvng (talk) 01:32, 1 September 2011 (UTC)[reply]

Back in September, Nono64 (talk · contribs) changed article title to Time base.... I've just edited the article body to match. --Kvng (talk) 03:50, 22 March 2012 (UTC)[reply]

Dropout Compensation?

The article mentions DOC (Dropout Compensation), but I'm not sure how this should be implementable within a TBC, which is externally connected to the video-signal. Dropouts are caused if the RF-Signal stored on the tape cannot be read back accurately (e.g. due to tape-defects or dust), which causes the RF-level to drop beyond a certain value. DOC-circuits are usually built into the replayers themselves, as they need to have access to the un-demodulated RF-signal in order to work. If an external TBC receives only the demodulated video signal (CVBS, Y/C, ...), it is already too late. Please correct me, if I'm wrong, but I think that DOC in an external TBC is not possible. The rooker (talk) 13:40, 20 March 2012 (UTC)[reply]

There were special RF outputs on some umatic recorders that fed a signal to the external TBC's DOC input. --StevenBradford (talk) 04:42, 26 July 2014 (UTC)[reply]

History section?

First production device? Different technologies? - Richfife (talk) 20:40, 10 July 2014 (UTC)[reply]