Talk:Thread angle

	Engineering portal This article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EngineeringWikipedia:WikiProject EngineeringTemplate:WikiProject EngineeringEngineering articles
???	This article has not yet received a rating on the project's importance scale.

Metalworking Low‑importance

	This article is within the scope of WikiProject Metalworking, a collaborative effort to improve the coverage of Metalworking on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking articles
Low	This article has been rated as Low-importance on the project's importance scale.

Panzergewinde

Could someone start Panzergewinde by translating de:Stahlpanzerrohrgewinde? Peter Horn User talk 02:48, 20 November 2010 (UTC)[reply]

Done. Panzergewinde (steel conduit thread). By the way, a related idle thought. Cheers. — ¾-10 18:30, 26 November 2010 (UTC)[reply]

Is there a term to describe the angle that a thread of a given pitch makes perpendicular to the threaded object. For instance a groove that goes around a pipe would be zero. A 24 tpi thread would make a fairly small angle compared to say an 8 tpi thread. I'm looking for a comparison between TPI and this angle. — Preceding unsigned comment added by 2001:5B0:2DFF:1EF0:0:0:0:38 (talk) 04:37, 10 September 2013 (UTC)[reply]

This angle question makes no sense. Peter Horn User talk 12:51, 10 September 2013 (UTC)[reply]

I think it does make sense, but the angle is just the ratio of the pitch to the circumference and is unrelated to the thread angle. I believe it is sometimes called the "spiral angle"

BA Threads

Perhaps BA threads should be included? They have an unusually low thread angle for a symmetrical V thread of 47/5 degrees. — Preceding unsigned comment added by Bodgesoc (talk • contribs) 09:57, 11 March 2015 (UTC)[reply]

Thread Angle

What is the angle of VA thread? 2409:4051:2ECA:2391:2031:51B0:EA44:CE27 (talk) 09:35, 28 March 2024 (UTC)[reply]