Jump to content

Talk:Stub (electronics)

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

Untitled

[edit]

Woah, it looks like this article went from an electronic circuit "stub" article to an autobiography of a musician. I'm going to restore this page and move the musician stuff to a new page called Devin Wardlaw. --Dirkbike 20:07, 24 September 2006 (UTC)[reply]

This section not entirely relevant

[edit]

This bit is only vaguely related to the main subject, so I've parked it here...

== Computer network stub ==
Electrical length = (Rise time) * (Speed of light) * (Cable propagation relative to light speed)
Maximum stub length = Electrical length * (1/6)[1]
This is relates to buses like SCSI, RS485, CAN-bus, Ethernet etc..
==References==
  1. ^ "Application Bulletin AB-6 RS-485 Systems--Making Them Work" (PDF). 071115 nve.com

...for the moment --catslash (talk) 00:42, 22 February 2009 (UTC)[reply]

Scattering

[edit]

It would be nice to explain stubs in terms of scattering rather than impedances; delayed-echo-from-end-of-stub-interferes-with signal-on-main-line sort of thing. It's more intuitive. --catslash (talk) 11:48, 22 February 2009 (UTC)[reply]

Resonant stub

[edit]

Similarly, a short circuit stub is an anti-resonator at pi/2, that is, it behaves as a parallel resonant circuit, but again fails as 3/2 pi is approached.

shouldn't it be

...but again fails as pi is approached?

No. Consider a stub being used as a band-pass filter on a main line. At π/2 the stub presents an open-circuit, has no effect on transmission on the main line, and we are in the middle of the filter's passband. At π the stub presents a short-circuit and we are fully in the filter's stopband. At 3π/2 however, the stub is once again an open-circuit and is now letting through frequencies that are supposed to be in the stopband and hence has completely failed. SpinningSpark 16:15, 11 August 2014 (UTC)[reply]
I think I got it. Thanks. I guess the difficult concept to grasp is that stubs are resonators (like a series resonant circuit; when short => minimum Z) and anti-resonators (like a parallel resonant circuit; when open => maximum Z) at the same time. The open circuit stub is said to behave like a series resonant circuit and to be open at βl =π (and integer multiples) and short at βl =π/2 (and integer multiples). On my side, I would have insisted on the double behaviour of stubs: they can resonate like a short series resonant circuit and anti-resonate like an open parallel resonant circuit. The same happens for both open circuit stubs and short circuit stubs but inversely:
open circuit stub
βl = π/2 (and integer multiples) => short series resonant circuit;
βl = π (and integer multiples) => open parallel anti-resonant circuit;
short circuit stub
βl = π/2 (and integer multiples) => open parallel anti-resonant circuit;
βl = π (and integer multiples) => short series resonant circuit;
--87.8.149.194 (talk) 12:06, 12 August 2014 (UTC)[reply]

Diagrams

[edit]

The sections on various stubs would benifit from wiring diagrams and circuit diagrams for their equivalent impedance (LC) circuits (circuit with corresponding lumped components).150.227.15.253 (talk) 11:30, 15 June 2017 (UTC)[reply]