Talk:Standard wire gauge

This article is within the scope of WikiProject Measurement, a project which is currently considered to be defunct.MeasurementWikipedia:WikiProject MeasurementTemplate:WikiProject MeasurementMeasurement articles

Engineering Low‑importance

	Engineering portal This article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EngineeringWikipedia:WikiProject EngineeringTemplate:WikiProject EngineeringEngineering articles
Low	This article has been rated as Low-importance on the project's importance scale.
	It is requested that a photograph, drawing, or other image be included in this article to improve its quality.

Obsolete?

Not really: http://www.rapidonline.com/Cables-Connectors/Cables/Wire/Nickel-chrome-wire/62487 Tabby (talk) 01:25, 13 May 2008 (UTC)[reply]

mmm, you still see it occasionally for some specalist wires but it's not exactly common. Normally we use metric measures of either CSA or strand count and strand diameter (often both are specificed). American sizes are also seen sometimes. 80.0.68.41 (talk) 03:00, 23 December 2010 (UTC)[reply]

Agreed. Not defunct. Sheet metal is still very much sold in SWG https://www.metalsupermarkets.co.uk/sheet-metal-gauge-chart/ — Preceding unsigned comment added by 195.194.10.190 (talk) 14:19, 27 October 2021 (UTC)[reply]

Units

Diameter? Cross section? Unfortunately I don't have a table to hand. Tabby (talk) 01:26, 13 May 2008 (UTC)[reply]

They're diameters Tabby (talk) 01:38, 13 May 2008 (UTC)[reply]

Also commonly used for sheet metal thickness. Old Aylesburian (talk) 13:42, 13 June 2008 (UTC)[reply]

Basic unit

"The basis of the system is the mil..." I'd suggest, as it's British Standard Wire Gauge, that the basis of the system is the thou. I've never heard an engineer in the UK say "mil" and mean 0.001". 80.4.149.253 (talk) 13:39, 15 November 2012 (UTC)[reply]

Step

Step in the table, what does that indicate? There's no explanation. Rob Kam (talk) 09:35, 29 March 2016 (UTC)[reply]

It appears to be the delta between adjacent gauges and would seem to be there to clarify the statement at the top of the table that it is piecewise linear. I.e., it marks the break points. SpinningSpark 18:38, 29 March 2016 (UTC)[reply]

A Commons file used on this page or its Wikidata item has been nominated for deletion

The following Wikimedia Commons file used on this page or its Wikidata item has been nominated for deletion:

Gauge Chart.pdf

Participate in the deletion discussion at the nomination page. —Community Tech bot (talk) 21:37, 12 July 2022 (UTC)[reply]