Talk:Pentagonal icositetrahedron

	Mathematics portal This article is within the scope of WikiProject Mathematics, a collaborative effort to improve the coverage of mathematics on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MathematicsWikipedia:WikiProject MathematicsTemplate:WikiProject Mathematicsmathematics
Low	This article has been rated as Low-priority on the project's priority scale.

Polyhedra Start‑class

	This article is within the scope of WikiProject Polyhedra, a collaborative effort to improve the coverage of polygons, polyhedra, and other polytopes on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.PolyhedraWikipedia:WikiProject PolyhedraTemplate:WikiProject PolyhedraPolyhedra
Start	This article has been given a rating which conflicts with the project-independent quality rating in the banner shell. Please resolve this conflict if possible.
???	This article has not yet received a rating on the project's importance scale.

darned good question

How the crap do you calculate volume and surface area assuming "unit edge length" when the faces are irregular polygons? There are two different edge lengths, so which one is the unit? — Preceding unsigned comment added by 69.128.4.10 (talk) 15:13, 28 August 2014 (UTC)[reply]

Face vs 3D Model Consistency Problem

Under the Geometry section, the dimensions of a face are based upon a short edge of unity length. However, under the Cartesian coordinates section, the short and long edge lengths are based upon the unity length of the dual Snub Cube. — Preceding unsigned comment added by 2601:602:9201:4050:5A55:CAFF:FEF1:2FAF (talk) 07:21, 6 June 2021 (UTC)[reply]

Scale Problem

Trying to use the info under the Cartesian coordinates section, after quite some head scratching, I was able to come up with the 12 each even and odd permutations and draw the figure in a spreadsheet, manually finding adjacent vertices to draw the edges to check for mistakes, but found that the small edges were all of length 2.712406131 and the large edges were all of length 3.850649402, all a factor of 4.570454036 larger than expected. — Preceding unsigned comment added by 2601:602:9201:4050:5A55:CAFF:FEF1:2FAF (talk) 07:21, 6 June 2021 (UTC) [reply]