Jump to content

Talk:Harry S. Truman Historic District

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia
[edit]

Hello fellow Wikipedians,

I have just modified one external link on Harry S. Truman Historic District. Please take a moment to review my edit. If you have any questions, or need the bot to ignore the links, or the page altogether, please visit this simple FaQ for additional information. I made the following changes:

When you have finished reviewing my changes, you may follow the instructions on the template below to fix any issues with the URLs.

This message was posted before February 2018. After February 2018, "External links modified" talk page sections are no longer generated or monitored by InternetArchiveBot. No special action is required regarding these talk page notices, other than regular verification using the archive tool instructions below. Editors have permission to delete these "External links modified" talk page sections if they want to de-clutter talk pages, but see the RfC before doing mass systematic removals. This message is updated dynamically through the template {{source check}} (last update: 5 June 2024).

  • If you have discovered URLs which were erroneously considered dead by the bot, you can report them with this tool.
  • If you found an error with any archives or the URLs themselves, you can fix them with this tool.

Cheers.—InternetArchiveBot (Report bug) 19:58, 30 October 2017 (UTC)[reply]

How to Fix Computer Overheating Caused by Blocked Heat Sink

[edit]

One of the biggest problems in PC desktop computers is overheating which can lead to random shutdown. This can be caused by blocked heat sink on the central processing unit. Here's how to solve that problem.

Unplug your computer before opening the case. Wear a static wrist guard if possible, or touch the metal case before handling anything inside, to ground any static charge you may have.


Consider other options first. Overheating issues are also often caused by poor air circulation in the computer case. If you have space, adding another fan can help. Also, you should regularly open the case unplug all the cords and carefully take your computer system outside use a can of compressed air or an air compressor. A small vacuum is a good second choice but you have to be careful not to hit any internal components with it, and avoid touching the circuit boards with anything. Take your time and be very thorough with this step. Next take a cotton swab dabbed in some rubbing alcohol and go over the internal case components to get them very clean. You can go over the external case with a rag and a little bit of water. Allow your system 2 hours to dry out before turning it back on.

Remove the small CPU fan plug from the motherboard. Grasp the plastic end and pull carefully until it comes out. Don't pull it by the wires.

Remove the CPU cooling fan. It may be held in place on the motherboard by four Phillips screws or a lock-down lever.

Release the CPU. Often it is held in place by a small lever that lifts to release the processor.


Take care not to drop the processor or pull it off if it's stuck. Dropping the processor will likely damage it. Alternatively, it may be stuck to the heat sink by thermal paste. Try to separate them. A credit card-type card can be useful for this step, but don't damage the CPU trying to pry them apart.

Clean out the heat sink. Blast compressed air directly on the heat sink. It only takes a few good quirts to clean a blockage. If it's persistent, allow a few seconds before repeating.

Carefully wipe off any residual thermal paste. Use a clean cotton bud or paper towel. A little rubbing alcohol may help, but too much could cause damage.

Replace the CPU in its socket.

Apply a thin layer of thermal paste to the top of the CPU. It only takes a small amount. Too much can cause overheating problems all over again.

Replace the heat sink. Clip the clip back in. Secure the fan back on. Plug it back into the motherboard.

Tidy up the case. Make sure stray wires are secured away from fans, then put the cover back in place.

Test your computer to make sure everything works or if still it doesn't works you may now proceed to get help from hp technical support.

Hoping this will help you through Wikipedia Article. — Preceding unsigned comment added by Philvthomas (talkcontribs) 06:10, 3 April 2018 (UTC)[reply]