Talk:Habrough railway station

Trains Portal

This article is within the scope of WikiProject Trains, an attempt to build a comprehensive and detailed guide to rail transport on Wikipedia. If you would like to participate, you can visit the project page, where you can join the project and/or contribute to the discussion. See also: WikiProject Trains to do list and the Trains Portal.TrainsWikipedia:WikiProject TrainsTemplate:WikiProject Trainsrail transport articles

Low

This article has been rated as Low-importance on the project's importance scale.

Associated projects or task forces:
/
	This article is supported by WikiProject Stations.
	This article is supported by WikiProject UK Railways (assessed as Low-importance).

This article lacks sufficient references and/or adequate inline citations.

Lincolnshire Low‑importance

	This article is within the scope of WikiProject Lincolnshire, a collaborative effort to improve the coverage of Lincolnshire on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.LincolnshireWikipedia:WikiProject LincolnshireTemplate:WikiProject LincolnshireLincolnshire articles
Low	This article has been rated as Low-importance on the project's importance scale.

Platforms

I notice the platforms are "staggered" ie. not opposite each other but are located on either side of the level crossing - the up on one side abd the down on the other. isn;t this a bit unusual? Silent Billy (talk) 22:30, 19 September 2012 (UTC)[reply]

It is unusual, although not unique. When I used Habrough station in about 1989-91 there was no footbridge; I don't think there is one even now. Habrough is the junction for the Barton-on-Humber branch, so passengers from the Doncaster, Retford or Lincoln direction wishing to travel onward to Barton (or vice versa) need to change platforms, by using the road and therefore the level crossing as well. Where a level crossing is close to a station, the rule is normally that the gates or barriers may not be opened until the train has passed through: consequently, if the platform was in rear of the l/c, the barriers would be held down until the train had departed. However, by placing the platform in advance of the l/c, the barriers may be raised as soon as the train has arrived. If the platforms were opposite each other (let's say on the Grimsby side of the road), and the trains were timed to arrive at the same time, the passenger from Doncaster would be trapped on platform 2 until the barriers lifted - which would only happen after the Barton train had left platform 1. By staggering them, the trains arrive, the barriers lift, the passengers cross over, the trains depart. --Redrose64 (talk) 16:16, 20 September 2012 (UTC)[reply]