This article is within the scope of WikiProject Science, a collaborative effort to improve the coverage of Science on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.ScienceWikipedia:WikiProject ScienceTemplate:WikiProject Sciencescience articles
This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
The article suggest that a disadvantage of the A-P winding for resistors is the need for four times the length of wire for a given resistance. Would using a thinner wire make up for the parallel windings therefore needing the same length of wire?
Tmiller11147 (talk) 20:28, 23 June 2013 (UTC)[reply]
This depends on your demands. With the same wire the resistor will become twice the length because the wires will cross twice per wound and lay side by side at the rest of the rod's scope. If you use the same rod length/scope and want to get the same resistor value you need approx. 0.63 x the wire diameter and 0,79 x the length of the single wirde wound resistor wire length.Ulfbastel (talk) 12:27, 25 August 2022 (UTC)[reply]
