Talk:7JP4

	Television portal This article is within the scope of WikiProject Television, a collaborative effort to develop and improve Wikipedia articles about television programs. If you would like to participate, please visit the project page where you can join the discussion. To improve this article, please refer to the style guidelines for the type of work.TelevisionWikipedia:WikiProject TelevisionTemplate:WikiProject Televisiontelevision articles
???	This article has not yet received a rating on the project's importance scale.

Please check electrical characteristics section for discrepancy.

There is a small but possibly confusing discrepancy in the 7JP4 Electical Characteristics section. I believe this should be cleared up for everyone's good.

The tube element naming is inconsistent between the text table and the hand drawn pinout image.

- image:
- https://en.wikipedia.org/wiki/7JP4#/media/File:7JP1,_7JP4_and_7JP7_Pin_Out_ID_and_Alignment.jpg

The hand drawn pinout image lists pin 9 as G2 (grid 2). It should be called A2 (second anode / anode 2) to align it with the data sheets. CRT data sheets almost always refer to the focus and acceleration elements as 'Anodes' rather than 'grids'.

Additionally, in the referenced External Links Datasheet PDF file, the base diagram/pinout is not clear.

There is a free-to-use very clear base diagram in page 1 of the data sheet referenced below. It is already a JPG.

page 1 http://www.bunkerofdoom.com/tubes/syl59/DATA/CRTS/7BP2A_2.JPG

page 2 http://www.bunkerofdoom.com/tubes/syl59/DATA/CRTS/7JP1_2.JPG

This data sheet also gives operating conditions for 4000V instead of 6000V on A2, which may or may not be of interest. — Preceding unsigned comment added by CRT Hobbyist (talk • contribs) 03:07, 8 April 2021 (UTC)[reply]