One-repetition maximum

One-repetition maximum (one-rep max or 1RM) in weight training is the maximum amount of weight that a person can possibly lift for one repetition. It may also be considered as the maximum amount of force that can be generated in one maximal contraction.^[1]

Usage

One repetition maximum can be used for determining an individual's maximum strength and is the method for determining the winner in events such as powerlifting and weightlifting competitions.

One repetition maximum can also be used as an upper limit, in order to determine the desired "load" for an exercise (as a percentage of the 1RM). Weight training protocols often use 1RM when programming to ensure the exerciser reaches resistance overload, especially when the exercise objective is muscular strength, endurance or hypertrophy. By understanding the maximal potential of the muscle, it is possible to reach resistance overload by increasing the number of repetitions for an exercise.

Measuring 1RM

Most commonly, 1RM is determined directly using trial and error testing. The participant lifts progressively heavier free weights, resting for several minutes between each attempt, until the maximum weight for which the participant can complete one full repetition is determined. The 1RM then lies between this weight and the next highest attempted weight. This type of assessment is considered the most accurate way to determine 1RM, and is considered safe when performed correctly. However, as adequate rest must be given between attempts, proper 1RM assessment may be very time-consuming if the initial weight is far from the 1RM.^[2]

Novices may find the procedure intimidating and unnerving, and be reluctant to add weight. There is also a risk of injury if a participant is unfamiliar with the proper form.^[2] A spotter can alleviate these concerns.

Estimating 1RM

The 1RM can also be estimated indirectly using repetition testing on submaximal loads, as popularized by the use of 1RM calculators. Although in many cases the estimate is reasonable, in other cases the estimate may vary by 10% or more from the actual 1RM.^[3] Using a specialized formula for the specific exercise improves accuracy.^[4] The use of anthropometric variables such as gender, age, height, weight, body fat percentage, and girth does not improve accuracy.^[5] Also, most formulas are for experienced weightlifters, and novices may find their actual one rep maximum is much lower because their nervous system cannot handle the stress of a high weight.

There are many formulas used to estimate 1RM using the submaximal method. In the formulas below, $r$ is the number of repetitions performed and $w$ is the amount of weight used (note that $w$ is a factor of each formula, so the unit of measurement doesn't matter).

Formulas for estimating 1RM
Name	1RM Formula
Epley^[6]	$w\left(1+r/{30}\right),$ assuming $r>1.$
Brzycki^[7]	$w\cdot {\frac {36}{37-r}}={\frac {w}{{\frac {37}{36}}-{\frac {1}{36}}r}}\approx {\frac {w}{1.0278-0.0278r}}$
Adams	$w\cdot {\frac {1}{1-0.02r}}$
Baechle	$w\cdot (1+0.033r)$
Berger	$w\cdot {\frac {1}{1.0261e^{-0.0262r}}}$
Brown	$w(0.9849+0.0328r)$
Kemmler et al. ^[8]	$w(0.988+0.0104r+0.00190r^{2}-0.0000584r^{3})$
Landers	$w\cdot {\frac {1}{1.013-0.0267123r}}$
Lombardi	$wr^{0.10}$
Mayhew et al.	$w\cdot {\frac {1}{0.522+0.419e^{-0.055r}}}$
Naclerio et al.^[9]	$w\cdot {\frac {1}{0.951e^{-0.021r}}}$
O'Conner et al.	$w\cdot \left(1+0.025r\right)$
Wathen	$w\cdot {\frac {1}{0.4880+0.538e^{-0.075r}}}$

Of the formulas, the Epley and the Brzycki formulas are most commonly used. Epley and Brzycki return identical results for 10 repetitions. However, for fewer than 10 reps, Epley returns a slightly higher estimated maximum. For example, if a person can lift 100 pounds on a given exercise for 10 reps, the estimated one rep max would be 133 pounds for both formulae. However, if the person were to complete only 6 reps, then Epley would estimate a one rep maximum of approximately 120 pounds, while Brzycki would return an estimate of approximately 116 pounds.

Several more complex formulae have been proposed which use different coefficients for different rep numbers and sometimes even for different exercises.^[10]^[11]^[12]

Compared to a formal 1RM test, the submaximal estimation method is safer and quicker.^[13] The estimate may not be accurate, but can be used as the starting point for a 1RM test. The formulas can also be used the other way, to calculate what weight is needed for a given repetition maximum, as a percent of the estimated or actual 1RM.

References

^ Marchese, Rosemary; Hill, Andrew (2011). The essential guide to fitness: for the fitness instructor. Sydney, NSW: Pearson Australia. p. 135. ISBN 9781442510203.
^ ^a ^b Mayhew, Jerry L; Johnson, Blair D; LaMonte, Michael J; Lauber, Dirk; Kemmler, Wolfgang (September 2008). "Accuracy of Prediction Equations for Determining One Repetition Maximum Bench Press in Women Before and After Resistance Training". Journal of Strength and Conditioning Research. 22 (5): 1570–1577. doi:10.1519/JSC.0b013e31817b02ad. PMID 18714230. S2CID 22631870.
^ Knutzen, Kathleen; Brilla, Lorraine; Caine, Dennis (August 1999). "Validity of 1RM Prediction Equations for Older Adults". The Journal of Strength & Conditioning Research. 13 (3): Vol 13, Issue 3, Page 242–246. Retrieved 11 July 2014.
^ Chapman, Paul P.; Whitehead, James R.; Binkert, Ronald H. (November 1998). "The 225–1b Reps-to-Fatigue Test as a Submaximal Estimate of 1-RM Bench Press Performance in College Football Players". Journal of Strength and Conditioning Research. 12 (4): 258–261. doi:10.1519/00124278-199811000-00010. S2CID 220562559.
^ Reynolds, JM; Gordon, TJ; Robergs, RA (August 2006). "Prediction of one repetition maximum strength from multiple repetition maximum testing and anthropometry" (PDF). Journal of Strength and Conditioning Research. 20 (3): 584–92. doi:10.1519/R-15304.1. PMID 16937972. S2CID 17050039.
^ Epley, Boyd (1985). "Poundage Chart". Boyd Epley Workout. Lincoln, NE: Body Enterprises. p. 86.
^ Brzycki, Matt (1998). A Practical Approach To Strength Training. McGraw-Hill. ISBN 978-1-57028-018-4.
^ Kemmler, Wolfgang K.; Lauber, Dirk; Wassermann, Alfred; Mayhew, Jerry L. (2006-11-01). "Predicting maximal strength in trained postmenopausal woman". Journal of Strength and Conditioning Research. 20 (4): 838–842. doi:10.1519/R-18905.1. ISSN 1064-8011. PMID 17194251. S2CID 12769411.
^ Naclerio Ayllón, Fernando; Jiménez Gutiérrez, Alfonso; Alvar, Brent A.; Peterson, Mark D. (2009). "Assessing strength and power in resistance training". Journal of Human Sport and Exercise. 4 (2): 100–113. doi:10.4100/jhse.2009.42.04.
^ LeSuer, Dale A.; McCormick, James H.; Mayhew, Jerry L.; Wasserstein, Ronald L.; Arnold, Michael D. (November 1997). "The Accuracy of Prediction Equations for Estimating 1-RM Performance in the Bench Press, Squat, and Deadlift". Journal of Strength and Conditioning Research. 11 (4): 211–213. doi:10.1519/00124278-199711000-00001. S2CID 144001941.
^ Earle; Baechle, eds. (2000). Essentials of Strength Training and Conditioning, 2nd edition. Champaign, IL: Human Kinetics. p. 395-425.
^ McNair, P.J.; Colvin, M.; Reid, D. (February 2011). "Predicting maximal strength of quadriceps from submaximal performance in individuals with knee joint osteoarthritis". Arthritis Care & Research. 63 (2): 216–222. doi:10.1002/acr.20368. PMID 20890972. S2CID 205221382.
^ Marchese, Rosemary; Hill, Andrew (2011). The essential guide to fitness: for the fitness instructor. Sydney, NSW: Pearson Australia. pp. 158–159. ISBN 9781442510203.

One-repetition maximum

Usage

Measuring 1RM

Estimating 1RM

See also

References

Further reading