Heaving to
In sailing, heaving to (to heave to and to be hove to) is a way of slowing a sailing vessel's forward progress, as well as fixing the helm and sail positions so that the vessel does not have to be steered.[1] It is commonly used for a "break"; this may be to wait for the tide before proceeding, or to wait out a strong or contrary wind. For a solo or shorthanded sailor it can provide time to go below deck, to attend to issues elsewhere on the boat or to take a meal break.[2][3] Heaving to can make reefing a lot easier, especially in traditional vessels with several sails.[4]: 113 It is also used as a storm tactic.[5]
A sailing vessel that is hove to is still, for the purposes of the collision regulations, on a defined tack. Therefore, unless other considerations dictate differently, it is helpful to heave to on the starboard tack, in order to be a "stand-on vessel", as per the regulations.[4]: 327
The term is also used in the context of vessels under power and refers to bringing the vessel to a complete stop. For example, in waters over which the United States has jurisdiction the Coast Guard may, under 14 U.S.C. §522, demand that a boat "heave to" in order to enforce federal laws.[6]
Hove to
[edit]
A sailing vessel is "hove to" when it is at or nearly at rest because the driving action from one or more sails is approximately balanced by the drive from the other(s). This always involves "backing" one or more sails, so that the wind is pressing against the forward side of the cloth, rather than the aft side as it normally would for the sail to drive the vessel forwards.[1] On a square rigged vessel with more than one mast, a number of options are available; these generally involve bracing round the square topsail on one or more masts to an aback position to counterbalance the sails that remain set in their normal position.[7]: 225–230 On a modern two-sailed sloop, there is only the jib and the mainsail. A cutter may have more than one headsail, and a ketch, yawl or schooner may have more than one sail on a boom. In what follows, the jibs and boomed sails on such craft can either be treated as one of each, or lowered for the purposes of reduced windage, heel or complexity when heaving to for any length of time.[8]
When a sloop is hove to, the jib is backed. This means that its windward sheet is tight holding the sail to windward. The mainsail sheet is often eased, or the mainsail reefed, to reduce forward movement, or "fore-reaching". The rudder is placed so that, should the boat make any forward movement, it will be turned into the wind, so as to prevent forward momentum building up.[9] In a centerboard boat the centerboard will be partially raised and the tiller held down hard.[10]
Heaving to
[edit]For a sloop sailing along normally, either of two maneuvers will render the sailboat to be hove to.
First, the jib can be literally heaved to windward, using the windward sheet and releasing the other.[5][11] Then the rudder would be put across so as to turn gently towards the wind. Without the drive of the jib, and allowing time for momentum to die down, the sailboat will be unable to tack and will stop hove to. This method may be preferable when broad reaching or running before a strong wind in a heavy sea and the prospect of tacking through the wind in order to heave to may not appeal. Bearing away from the wind so that the headsail is blanketed by the mainsail can make it easier to haul in the windward sheet.
Alternatively, the vessel can simply be turned normally to tack through the wind, without freeing the jibsheet.[5][1][11] The mainsail should self-tack onto the other side, but the jib is held aback. Finally the rudder is put the other way, as if trying to tack back again. Without the drive of the jib, she cannot do this and will stop hove to. This method is fast to implement and is recommended by sail training bodies such as the RYA as a "quick stop" reaction to a man overboard emergency, for sailing boats that have an engine available for further maneuvers to approach and pick up the casualty.[12]
Finally, in either case, the tiller or wheel should be lashed so that the rudder cannot move again, and the mainsheet adjusted so that the boat lies with the wind ahead of the beam with minimal speed forward. Usually this involves easing the sheet slightly compared to a closehauled position, but depending on the relative sizes of the sails, the shape and configuration of the keel and rudder and the state of the wind and sea, each skipper will have to experiment.[8][1] After this the boat can be left indefinitely, only keeping a lookout for other approaching vessels.
When hove to, the boat will heel, there will be some drift to leeward and some tendency to forereach, so adequate seaway must be allowed for. In rough weather, this leeway can actually leave a "slick" effect to windward, in which the waves are smaller than elsewhere.[8] This can make a rest or meal break a little more comfortable at times.
To come out from the hove-to position and get under way again, the tiller or wheel is unlashed and the windward jibsheet is released, hauling in the normal leeward one. Bearing off the wind using the rudder will get the boat moving and then she can be maneuvered onto any desired course.[9] It is important when choosing the tack, heaving to, and remaining hove to, in a confined space that adequate room is allowed for these maneuvers.[13]
Heaving to as a storm tactic
[edit]Heaving to has been used by a number of yachts to survive storm conditions (winds greater than Force 10, 48–55 knots, 89–102 km/h, 55–63 mph).[5] During the June 1994 Queen's Birthday Storm,[14] all yachts that hove to survived the storm.[15] This included Sabre, a 10.4 m (34 ft) steel cutter with two persons on board, which hove to in wind speeds averaging 80 knots for 6 hours with virtually no damage.[5][16]
During the ill-fated 1979 Fastnet race, of 300 yachts, 158 chose to adopt storm tactics; 86 "lay ahull", whereby the yacht adopts a "beam on" attitude to the wind and waves; 46 ran before the wind under bare poles or trailing warps/sea anchors, and 26 hove to. 100 yachts suffered knock downs; 77 rolled (that is turtled) at least once. Not one of the hove to yachts were capsized (knocked down or turtled) or suffered any serious damage.[17] The "heave to" maneuver is described in the story of the first Golden Globe yacht race of 1968.[18]
See also
[edit]- Anchor – Device used to secure a vessel to the bed of a body of water to prevent the craft from drifting
- Drogue – Drag device streamed behind a vessel
- Mooring – Structure for securing floating vessels
- Sea anchor – Drag device used to stabilize a boat in heavy weather and reduce drift
- Seakeeping – Response of a vessel to sea conditions
- Seamanship – Art, competence, and knowledge of operating a craft on water
References
[edit]- ^ a b c d Schell, Andy (21 January 2013). "Cruising Tips: Heaving-To". Sail Magazine. Retrieved 21 June 2017.
- ^ www.sailingusa.info/points_of_sail.htm Archived June 26, 2006, at the Wayback Machine
- ^ "Heavy weather conditions at sea (pictures and further explanation)". Retrieved 17 April 2015.
- ^ a b Cunliffe, Tom (2016). Hand, Reef and Steer: Traditional Sailing Skills for Classic Boats (second ed.). Adlard Coles. ISBN 978-1472925220.
- ^ a b c d e Bruce, Peter (2016). Heavy Weather Sailing (7th ed.). Bloomsbury. pp. 192–195. ISBN 9781472928207. Retrieved 21 June 2017.
- ^ "18 U.S. Code § 2237 - Criminal sanctions for failure to heave to, obstruction of boarding, or providing false information". LII / Legal Information Institute. Retrieved 2022-11-13.
- ^ Harland, John (2015). Seamanship in the age of sail : an account of shiphandling of the sailing man-o-war, 1600-1860. London. ISBN 978-1-8448-6309-9.
{{cite book}}: CS1 maint: location missing publisher (link) - ^ a b c Pardey, Lin (2008). Storm Tactics Handbook, 3rd Ed., Modern methods of heaving-to for survival in extreme conditions. Arcata, California: Pardey Books. pp. 44–48. ISBN 978-1-92921-447-1.
- ^ a b "Heaving To - Parking your boat without anchoring". Coastal Boating.net. Retrieved 21 June 2017.
- ^ "Heaving to and the centerboard". The Trailorsailor. Retrieved 21 June 2017.
- ^ a b "How to manoeuvre under sail". How to cruise under sail - Safety and comfort for live-aboard, long-distance sailors. 23 June 2010. Retrieved 21 June 2017.
- ^ Pearson, Malcolm (2007). Reeds skipper's handbook: for sail and power. London: Adlard Coles Nautical. p. 127. ISBN 978-0-7136-8338-7.
- ^ Pardey 2008, p. 116.
- ^ Bruce 2016, pp. 241–253.
- ^ Bruce 2016, p. 248.
- ^ Taylor, Kim (1996). The 1994 Pacific Storm Survey. Auckland, N.Z.: Captain Teach Press and Quarry Pub. p. 10. ISBN 1-877197-11-4. OCLC 154204736.
- ^ Pardey 2008, p. 97.
- ^ Nichols, Peter (2002). A Voyage For Madmen. London: Profile Books. p. 320. ISBN 978-1861974655.
