badblocks
 |
badblocks is a Linux utility to check for bad sectors on a disk drive. It can create a text file with list of these sectors that can be used with other programs, like mkfs, so that they are not used in the future and thus do not cause corruption of data. It is part of the e2fsprogs project,[1] and a port is available for BSD operating systems.[2]
When run as a standalone program, badblocks gives a list of blocks with problems, if any. This makes it a good option for checking whether the disk drive is healthy, independent of SMART data and file system checks.[3]
e2fsck's "-c" option
[edit]A more common use case is the invocation of badblocks as part of e2fsck when passing the option "-c" to scan for bad blocks and prevent data from being stored on these blocks. This is done by adding the list of found bad blocks to the bad block inode to prevent the affected sectors from being allocated to a file or directory. The test can be done using a read-only ("-c") or non-destructive read–write ("-cc") test method.[4]
dumpe2fs
[edit]Running dumpe2fs -b will display the list of bad blocks recorded by e2fsck or tune2fs.
Examples
[edit]badblocks -nvs /dev/sdb
This would check the drive "sdb" in non-destructive read–write mode and display progress by writing out the block numbers as they are checked.
badblocks -wvs /dev/sdb6
This would check the sixth partition of the drive "sdb", in destructive read–write mode (-w = write-mode), which writes 4 different patterns on the whole partition and verifies each by reading back. It displays progress by writing out the block numbers as they are checked (-s = show, -v = verbose). All data on the partition will be overwritten at the block level.
badblocks -wvsb 4096 /dev/sdb
This does the same as above, but to the entire drive, with a block size (-b) of 4096. This destroys MBRs, partitions and data alike. Modern disk drives will probably not show any defective sectors because they silently remap bad sectors to spare tracks,[5] but running the program with a new drive for several days will test the whole surface, and when reading it afterwards S.M.A.R.T. data will eventually show reallocated sectors.
Using the -w option on a device containing an existing file system erases the data on that device.
References
[edit]- ^ E2fsprogs: Ext2/3/4 Filesystem Utilities – Release notes
- ^ FreshPorts – sysutils/e2fsprogs
- ^ – Linux Administration and Privileged Commands Manual
- ^ – Linux Administration and Privileged Commands Manual
- ^ "Bad Sector Remapping|Articles|Data Recovery Services: 0800 072 3282". Archived from the original on 2012-07-19. Retrieved 2012-06-30.
External links
[edit]- Smartmontools – Bad block HOWTO for smartmontools. A complex how to for badblocks; might be confusing for the casual user.
- Badblocks - ArchWIKI