Jump to content

North Carolina State University reactor program

Coordinates: 35°47′09″N 78°40′08″W / 35.78585241745253°N 78.66894524996331°W / 35.78585241745253; -78.66894524996331
From Wikipedia, the free encyclopedia
(Redirected from Pulstar (nuclear reactor))
Pulstar
Picture of R-1 reactor while under construction [1]
Operating InstitutionNorth Carolina State University
LocationRaleigh, North Carolina
Typepool
Power1 MW (thermal)
Construction and Upkeep
Construction Cost$1.5 million USD
Construction BeganJune 1, 1969
First CriticalityJanuary 1, 1972
Staff7
Operators3
Technical Specifications
Max Thermal Flux1.1e13 n/cm^2-s
Fuel TypeU02 pellets, pin lattice
Coolingn/cm^2-s
Neutron Moderatorlight water
Neutron Reflectorgraphite, beryllium
Control Rods4 Rods
Cladding MaterialZirconium Alloy
Source(s): IAEA Database of Reactors data from 2002-09-04

North Carolina State University in 1950 founded the first university-based reactor program and Nuclear Engineering curriculum in the United States. The program continues in the early 21st century. That year, NC State College administrators approved construction of a reactor and the establishment of a collegiate nuclear engineering program.[2] The first research reactor was completed in 1953;[3] it was scaled up in 1957 and 1960 (referred to as R-1, R-2, and R-3). It was deactivated in 1973 to make way for the PULSTAR reactor. The old reactor has been decommissioned.

The PULSTAR is used for a variety of purposes, including training and research. The reactor is located in Burlington Engineering Laboratories on NCSU's main campus. This facility was built to house the first reactor and then expanded and renamed when the PULSTAR was built. The current reactor is one of two PULSTAR reactors built, and the only one still in operation. The other reactor was a 2 MW reactor at the State University of New York at Buffalo. It went critical in 1964 and was decommissioned in 1994.[4]

Current reactor operations

[edit]
The "observation room" of NC State's Pulstar Nuclear Reactor.

The PULSTAR reactor is situated along Engineering Row in the main campus, surrounded by Mann Hall, 111 Lampe Drive, Polk Hall, and a park. The reactor has a dedicated building and uses one cooling tower; it releases water vapor when the reactor is at high power. This building is not a Containment building, but it maintains a negative pressure to prevent any release of radioactive material. The reactor can be operated up to a power of 100 kW on natural circulation, or 1 Megawatt (MW) with the use of pumps.[4]

The reactor enriches the department curricula by providing hands on experience as well as training for students. In 2002, department enrollment was 72 total undergraduate students, 15 masters students, and 22 PhD students,[5] all of whom use the reactor. Additionally, 34 researches outside of Nuclear Engineering use the reactor and associated facilities.[6]

The primary research purpose of the reactor is to provide a neutron source for activities such as Neutron activation analysis. For example, cobalt-60 irradiators are used by a number of departments to sterilize biological samples. It is also used for professional training for nuclear utility operators and engineers, DOE Interns, and State and local radiation protection personnel.[6]

This reactor is well suited for duplicating the fuel performance of power reactors. The core consists of low-enriched Uranium pins intended to be very similar to what is used in commercial nuclear power plants.[7] Five beam ports are adjacent to the core of the reactor. This reactor is well suited for experiments requiring a large neutron flux because peaking occurs around the edge of the core due to under moderation. In September 2007, students, faculty and staff produced the most intense operating positron beam anywhere in the world.[8]

The PULSTAR reactor is a public facility and gives frequent tours with advance notice and clearance.

In November 2010, the PULSTAR reactor was linked to the nuclear engineering department of Jordan University of Science and Technology (JUST).[9][10]

Incidents

[edit]

A water leak was detected in the pool, and the reactor was subsequently shut down on July 2, 2011. The leak rate was said to be 10 US gallons per hour (11 L/ks) (out of a 15,600-US-gallon-pool (59,000 L)), which is far below the 350 US gallons per hour (370 L/ks) that is mandated to be officially reported to the regulator. The leak was said to be "pinhole" size and required special equipment to detect.[11] After the leak was located and repaired, technicians returned the reactor to normal operations.

Early history

[edit]

The first reactor was a part of a 1-story building called Burlington Nuclear Laboratories at the time and currently referred to as the old building of the Burlington Engineering Labs, which has classrooms surrounding the reactor bay. The old building is still in use with the reactor bay housing various new projects. The reactor itself has been completely decommissioned and moved out.

R-1

[edit]

In 1949, Dr. Clifford K. Beck was recruited from the Oak Ridge National Laboratory to join the faculty with plans to make NCSU the first academic institution to operate a nuclear reactor.

The first reactor at an academic institution went critical on September 5, 1953, approximately four years after construction had been started. This reactor was dubbed R-1 because it was the first university research reactor. It was a 10 kW, homogeneous reactor using highly enriched Uranyl Sulfate as fuel. It operated for a short time but was shut down due to corrosion problems that lead to fuel leakage. Howard Blakeslee, science editor of Associated Press Service, called the reactor the First Temple of the Atom because of the public nature of this reactor.

In 1954 construction of Burlington Nuclear Laboratory began with funds from the AEC and Burlington Mills. The purpose of this building was to house the successor to the R-1. Also in 1954 the first two PhDs in Nuclear Engineering were presented.[12]

In 1955, Dr. Raymond L. Murray, another recruit from Oak Ridge National Laboratory, joined the faculty, who later became the longest serving department head.[7]

R-3

[edit]

In 1956 work to build a heterogeneous reactor called R-3 began. This design was to use Materials Test Reactor plate-type fuel in Burlington Nuclear Labs. This reactor operated at a maximum power of 100 kW.

In the late 1950s, Dr. Raymond L. Murray became head of the Applied Physics department where he also provided leadership to the beginning of a nuclear engineering educational program. The decision was made to offer the first B.S. degree in Nuclear Engineering in the nation. In 1956 Clifford Beck departed the program to accept a position with the Atomic Energy Commission in Washington. Raymond Murray and Professor Harold Lammonds assumed supervision of the nuclear program.

Between 1962 and 1964, the shielding of the R-3 reactor was extended to allow operation at higher power levels and this improved reactor began operation in 1963, operating at a steady-state power level of 250 kW. This reactor became a major part of the nuclear engineering instructional program and also began to provide some services in radioisotope production and neutron activation analysis.

In 1963 Raymond Murray resigned his position as head of Applied Physics to become Department Head of Nuclear Engineering. Simultaneous with this decision, the Nuclear Engineering Department was transferred from Applied Physics into the School of Engineering, then headed by Dr. Ralph E. Fadum, Dean.

Through the late 1960s and early 1970s the Air Force and Army began to send qualified students to the program to obtain M.S. degrees and later staff the nuclear programs in their own organizations. In the 70's, the NESEP program (Naval Enlisted Scientific Education Program) brought a number of well qualified enlisted men into the nuclear program to earn undergraduate degrees and a number of foreign countries contributed students to earn BS, MS or PhD degrees and then return to their respective countries.[7]

By the time of shutdown, the reactor had achieved a total of 2 Megawatt-days of operation.[13]

History after construction of the PULSTAR

[edit]
View looking down on the reactor pool

Internal discussions within Nuclear Engineering addressed the choices of upgrading the R-3 reactor for both teaching and research or shutting it down to replace it with an entirely new reactor. Dr. Martin Welt championed the latter point of view, and this position was adopted by the department.

A new 3-story addition to Burlington Labs was constructed (known as the new building). Between it and the old building, a reactor building was constructed, along with a loading dock and walkway that bridged the old and new buildings. The reactor building housed the 1 MW pool nuclear reactor manufactured by AMF and known as the "Pulstar" reactor. It was named for its pulsing ability, by which it can safely become super prompt critical and produce very short pulses of radiation. The reactor became operational August 25, 1972, replacing the previous series.[14] The initial costs were reported to be 1.5 M US$.

In the 1980s a Prompt Gamma facility and a Neutron Radiography facility were added. The prompt gamma facility performs the analysis of elements that emit characteristic signatures immediately on neutron capture. The Neutron Radiography facility provides imaging capabilities to the fundamental difference in the interaction of neutrons with nuclei in comparison to the interaction of x-rays and electrons.[15]

In 1997 the Nuclear Regulatory Commission approved a 20-year license extension.[16]

The Pulstar reactor is currently running at 1MW which is the maximum power output that it can legally reach. It has plans to move up to 2 MW in the future. Preparations are done and all they are waiting for is approval. Moving to 2 MW will allow for more research to undergo with more radiation and power.

Facilities

[edit]

Neutron Imaging Facility

[edit]

Neutron radiography is a powerful non-destructive imaging technique for the internal evaluation of materials or components. It involves the attenuation of a neutron beam by an object to be radiographed, and registration of the attenuation process (as an image) digitally or on film. Neutron radiography is similar in principle to X-ray radiography, and is complementary in the nature of information supplied. The interactions of X-rays and neutrons with matter are fundamentally different, however, forming the basis of many unique applications using neutrons. While X-rays interact with the electron cloud surrounding the nucleus of an atom, neutrons interact with the nucleus itself. For more information see neutron radiology.

Ultra Cold Neutron Source

[edit]

The Ultra Cold Neutron Source (UCNS) uses neutrons produced in the reactor by slowing them down through a chamber of methane and other materials and holds them in a tank of D2O. This addition is essentially a tap of neutrons from a beamport adjacent to the reaction to do this research.

References

[edit]
  1. ^ "R-1 reactor", University Archives
  2. ^ "Nuclear engineering program approved (1950)". Historical State: History in Red and White. NCSU Special Collections Research Center. Retrieved 11 January 2012.
  3. ^ "Nuclear reactor goes into operation (9/5/1953)". Historical State: History in Red and White. NCSU Libraries Special Collections Research Center. Retrieved 11 January 2012.
  4. ^ a b IAEA Database of Reactors "Nuclear Research Reactors in the World". Archived from the original on 2008-05-16. Retrieved 2008-06-11., data from 2002-09-04
  5. ^ "Department of Physics".
  6. ^ a b Binney, S.E.; S.R. Reese; D.S. Pratt (February 22, 2000). "University Research Reactors: Contributing to the National Scientific and Engineering Infrastructure from 1953 to 2000 and Beyond". National Organization of Test, Research and Training Reactors. Archived from the original on July 1, 2007. Retrieved 2007-04-07.
  7. ^ a b c Kosmerick, Todd. "NCSU Nuclear Engineering Department Milestones" (PDF). Retrieved 2007-04-07.
  8. ^ Dave Pond, NCSU, Innovation-Discovery, October 2007
  9. ^ "Jordan inaugurates Internet Reactor Laboratory". Ammonnews. 1 November 2010. Retrieved 22 April 2013.
  10. ^ "University of Science and Technology Launches a nuclear reactor laboratory via the Internet". Almadenah news. 1 November 2010. Retrieved 22 April 2013.
  11. ^ NBC 17 staff (7 July 2011). "NCSU discovers leak in its nuclear reactor". NBC 17. Retrieved 15 July 2011.{{cite news}}: CS1 maint: numeric names: authors list (link)
  12. ^ State Nuclear Industry – North Carolina Archived 2008-10-24 at the Wayback Machine
  13. ^ www-pub.iaea.org/MTCD/publications/PDF/D446_web/6_DD_Table.pdf
  14. ^ "Noah's Ark: Non-Power Reactors in America". Retrieved 22 April 2013.
  15. ^ Nuclear Reactor Program
  16. ^ "Reactor Given 20-year Relicensing". 27 June 1997. Retrieved 22 April 2013.
[edit]


35°47′09″N 78°40′08″W / 35.78585241745253°N 78.66894524996331°W / 35.78585241745253; -78.66894524996331