Jump to content

Cotter (pin)

From Wikipedia, the free encyclopedia
(Redirected from Gib and cotter)
Cross-section of a connecting rod, showing strap (S), gib (G), and cotter pin (C)
Another view, with scale, of bicycle crank cotter

A cotter is a pin or wedge with a flat bearing surface passing through a hole to fix parts tightly together. In British usage cotter pin has the same meaning,[1] but in the U.S. it means a split pin.

Typical applications are in fixing a crank to its crankshaft, as in a bicycle, and a piston rod to a crosshead, as in a steam engine. The angle of the wedge determines the position of the parts being held; therefore, on a bicycle, the pedal arms will only be at 180 degrees to each other if the angle of the cotter pin's wedge is the same on both pins.

[edit]
Bracelet links connected by cotter pins

Formerly, it was common to mount bicycle cranks using a cotter, although now a more easily maintained arrangement is typically used, such as a square tapered or splined interface. These cotters have a short threaded section at the narrower end of the taper, which is used to hold the cotter in place with a washer and nut. They are also used to secure ceiling fans to prevent falling if the mounting nut loosens.

See also

[edit]
  • Bottom bracket – Bicycle component
  • Crankset – Bicycle part
  • Mechanical joint – Section of a machine which is used to connect one mechanical part to another
  • Split pin – Metal fastener with two tines that are bent during installation
  • Taper pin – Fastener consisting of a conical rod with a shallow taper which is forced into a hole

References

[edit]
  1. ^ Van der Plas, Rob (1993), The Bicycle Repair Book: The New Complete Manual of Bicycle Care (2nd ed.), MBI Publishing Company, p. 66, ISBN 978-0-933201-55-2[permanent dead link].
[edit]