A 1" x 3" x 7" pine board, finished with a UV cure resin (not sanded), then exposed to various time exposures of UVA (primarily 370nm +/-10nm, less than 3% UVB at 312-315nm). Left side was exposed 43 hours, center band was shielded and received no UVA except to cure the finish, the right side was exposed for 20 hours. Exposure done with 4 SunMaster Curall UV resin curing lamp (F32T8 reflector lamp powered at 50 watts. Total UV at surface (as measured with a UVA/B meter) was approximately 15 mW/cm2 for the duration of the tests. Demonstrates the effects of ultraviolet on finished wood surfaces.
to share – to copy, distribute and transmit the work
to remix – to adapt the work
Under the following conditions:
attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
share alike – If you remix, transform, or build upon the material, you must distribute your contributions under the same or compatible license as the original.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts. A copy of the license is included in the section entitled GNU Free Documentation License.http://www.gnu.org/copyleft/fdl.htmlGFDLGNU Free Documentation Licensetruetrue
You may select the license of your choice.
Captions
Add a one-line explanation of what this file represents
{{Information |Description=A 1" x 3" x 7" pine board, finished with a UV cure resin (not sanded), then exposed to various time exposures of UVA (primarily 370nm +/-10nm, less than 3% UVB at 312-315nm). Left side was exposed 43 hours, center band was s...