Jump to content

File:Crystal radio circuit with bias and buzzer.svg

Page contents not supported in other languages.
This is a file from the Wikimedia Commons
From Wikipedia, the free encyclopedia

Original file (SVG file, nominally 672 × 672 pixels, file size: 43 KB)

Summary

Description
English: A crystal radio receiver circuit with detector bias battery and testing buzzer. This type receiver circuit was used with cat's whisker detectors during the wireless telegraphy era prior to the 1920s. Many of the crystals used in early cat's whisker detectors, particularly carborundum (silicon carbide), had large band gaps (forward voltage drops). These weren't very efficient rectifiers in crystal radios, because the low voltage signal from the antenna had to overcome the device's forward voltage drop, and so was insufficient to drive the device far into its conduction region, so it had a large AC resistance. To make the detector D1 more sensitive, an adjustable bias voltage equal to the forward voltage drop is applied by battery B1 and potentiometer R1 across the detector. For silicon carbide about 1 V was used. R1 was adjusted until the radio station sounded loudest in the earphone. The bias moved the DC operating point to the most sensitive "knee" of the detector's IV curve
The cat's whisker detector D1 consisted of a fine wire touching the surface of a piece of crystal. The metal-crystal contact functioned as a primitive PN junction, allowing current to flow in only one direction. Only certain sites on the crystal surface functioned as rectifying junctions, so an active site had to be found by trial and error before each use. The operator dragged the wire across the crystal surface until the detector began functioning. The battery-powered buzzer circuit (B2, BZ, S1) generated a test signal to determine if the detector was functioning. Switch S1 was closed and the electromagnet-operated buzzer BZ was turned on while the detector was adjusted. The sparks at the buzzer's contacts acted as a weak radio transmitter, and its signal was applied to the receiver's ground wire. So when the right spot on the detector was found, the buzz could be heard in the earphones. Then the buzzer was turned off.
Date
Source Own work
Author Chetvorno
SVG development
InfoField
 
The SVG code is valid.
 
This diagram was created with Inkscape, or with something else.
 
This diagram uses translateable embedded text.

Licensing

Public domain I, the copyright holder of this work, release this work into the public domain. This applies worldwide.
In some countries this may not be legally possible; if so:
I grant anyone the right to use this work for any purpose, without any conditions, unless such conditions are required by law.

Captions

Circuit of a crystal radio

Items portrayed in this file

depicts

28 May 2010

image/svg+xml

474040fb8d5cc01e0a7f37eafba451799584f248

44,265 byte

672 pixel

672 pixel

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current04:12, 9 May 2017Thumbnail for version as of 04:12, 9 May 2017672 × 672 (43 KB)ChetvornoReplaced with "plain SVG" version that passes validation
02:19, 28 January 2016Thumbnail for version as of 02:19, 28 January 2016672 × 672 (56 KB)ChetvornoIncreased line width and tweaked location of components
06:17, 29 May 2010Thumbnail for version as of 06:17, 29 May 2010686 × 688 (58 KB)Chetvorno{{Information |Description=A Wikipedia:crystal radio circuit with detector bias battery and testing buzzer. This type circuit was used with Wikipedia:cat's whisker detectors during the wireless telegraphy era prior to the 1920s. Many of the cry

The following 2 pages use this file:

Global file usage

The following other wikis use this file:

Metadata